Nano Switch with Power Metering

Close your motorized windows automatically if it starts raining or shut down your shades if it is to warm outside. The Aeotec Nano Shutter enables you to control a broad selection of devices wirelessly and intelligently. The module equips motors for shutters, shades, garage doors, venetian blinds, etc. with Z-Wave technology. Thus, shutters and venetian blinds can be controlled both wirelessly via Z-Wave commands and locally via the connected conventional wall switch. The Aeotec Nano Shutter is designed to be mounted inside a flush mounting box, hidden behind a conventional wall switch.

The AEOTEC Nano Dimmer is a flush-mounted radio module which turns a standard light installation into an intelligent smart home component with Z-Wave wireless technology.

The compact radio module is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as input device for the AEOTEC insert that is controlling the load. The switch only sends control signal to the insert which controls (switch/dim) the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box and the amount of additional cabling placed in this box.

With the AEOTEC Dual Nano Switch all switchable and non-dimmable electric installations (e.g. lighting, sockets...) can be integrated into a Z-Wave network. Thus, the connected load can be switched both wirelessly via Z-Wave and locally via existing wall switch.

The compact radio module (60% smaller than its predecessor Micro Smart Switch) is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as input device for the AEOTEC insert that is controlling the load. The switch only sends control signal to the insert which controls the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box and the amount of additional cabling placed in this box.

Additionally, the ZW132 has an integrated power metering function which allows to detect the exact energy consumption of the connected load.